ULTIMATE PROJECT CRAWLER COMPLETED!!! SUCCESS!!

After hours of hard work finally the conversion from stock mini monster truck to profesinal grade super crawler have finally reach its goal. Super flex torsion axle, longer stable stance and 100% terrain crawler with high power climbing rate equal to AXIAL AX10 crawling capability. With Tamiya CR01 driveshaft, MAMBA 25 ESC, 2.4Ghz and dual steering front and rear... no terrains or obstacles can stop this might beast. Would like to thanks our Member Crawler community from rctech for supply me crawler parts. This is rock crawler at its best! will post you the video too hehehehehehe...

First i would like to thanks to member of rctech (http://www.rctech.net) "Ecrawler" for reserving me his stock Huanqi mini monster (A-Tech Leo-x) for my conversion work to full pro spec crawler. Took me around 11 hours of work to convert an innocent shorty mini monster to extreme crawler spec.

Construction Material:
-------------------------------
-Huanqi mini monster stock models (1/20 scale - 'aka' A-Tech Leo-x model)
-2.4Ghz Sanwa receiver
-Castle Creation: MAMBA 25 Brushless ESC
-4x steel clip rods + 6x mini radio antenna (For lower axle push rod and mid drive shaft rods)
-4x extended slim push rods for front and rear steering and center axle positioning
-Lipo 2s 800mah 15c batt
-4x Plastic rod wall concrete insert ( for adapter to attached Tamiya CR01 adjustable drive shaft to axle and gear box)
-TAMIYA CR01 adjustable drive shaft


Useless stuff to be thrown off from chassis:
-------------------------------------------------------------
-Stock Rx and TX
-Stock 50A Brushed ESC
-Nimh 7.2v batt
-4x stock push rod axle
-2x short mid drive shaft

Work hours - 11hrs

-------------------------------------------------------------------------------------Performance:
What can i say it climbs like a spider!!!...that is when i use brushless 4200KV motor + 8T HPI RS4 micro pinion gear).


Photo: